top of page
Writer's picturelms editor

MATLAB Implementation of Single Stage Three Phase Grid-connected PV Systems

MATLAB Implementation of Single Stage Three Phase Grid-connected PV Systems


Step-by-step implementation of a state-of-the-art grid-connected photovoltaic (PV) system. We will design a 100 kilowatt (kW) grid-connected PV system, detailing the entire process from setting up the PV array to connecting the inverter.




Simulation and Tuning

Simulation Setup:


Implement the PV array, MPPT algorithm, and inverter control in a simulation tool.

Set sample time and solver configuration.

Tuning the PID Controller:


Use a PID tuner to identify the plant and tune the PID controller parameters.

Simulate the model and adjust parameters to minimize oscillations and harmonics.

Results and Analysis

Power Output:


Verify that the system generates close to 100 kW under standard test conditions (STC).

Current and Voltage Quality:


Ensure that the output current and voltage are within acceptable harmonic distortion levels.

Measure the total harmonic distortion (THD) to ensure it is below 5%.

Dynamic Response:


Test the system's response to changes in irradiation levels to ensure stability and reliability.


Conclusion

This step-by-step implementation guide provides a comprehensive approach to designing and simulating a 100 kW grid-connected PV system. By following these steps, you can ensure efficient power generation and high-quality output suitable for grid integration.

11 views0 comments

Comments


bottom of page